As my knowledge of 3D design grows I'm revisiting some of my older designs, and since my old iPhone 6/6S Plus mount for my micstand is getting a bit long in the tooth I thought it was a good idea for me to pull my finger out and update the thing. Therefore here's the Mk 2 version, which hopefully is an improvement. This version comes in two seperate sections, the universal stand mount and the phone holder. The actual phone holding cradle has the ability to be mounted on either the left or right hand side of the stand for left or right handed people, but must be glued in so make sure you don't change your mind! I recommend gluing a strip of rubber into the aperture on the stand mount to make sure it grips tightly. On the stand mount interface put the hub through the big hole and then glue the hub holder onto the mount, sighting it on the two mounting pins. Then glue the hub into the hole on whichever side of the phone mount you want to mount it on.
(My printer is out of action at the moment so I'm uploading this for testing. Many thanks in advance to whomever is testing it, I'd have tested it myself if I could and not put you through all the misery I promise!)