Snapmaker 2.0 3d printing modular holder
Snapmaker 2.0 3d printing modular holder
3D
Published 2020-05-10T07:55:15+00:00
Snapmaker 2.0 3d printing holder, can also be used for the laser Modular. the holder will shift the modular by 6.30mm forward on the Y-Axis. keep that in mind when work on your designs for both 3d printing and laser engraving.
********IMPORTANT!!! :
if the print shrank or didn't come out correct in measurements you might need to do some hand file in order to fit the holder correctly.
print with support (Recommended: Lines 10% or less)
Preferable but not necessary: printing in an enclosure.
Minimum infill ratio: 15%.
to fix the Modular on the holder you will need extra 4x M4x8mm Hex Screws exactly as the one that comes with the snapmaker 2.0
To fix the lever, you will need the following:
1X M4x16 flat screws.
1X M4 nut. (the hole is hexagonally shaped for nut with 6.90mm in width)
Snapmaker 2.0 3d printing holder, can also be used for the laser Modular. the holder will shift the modular with 6.30mm forward on the Y-Axis. keep that in mind when your designs for both 3d printing and laser engraving.
********IMPORTANT!!! :
if the print shrank or didn't come out correct in measurements you might need to do some hand file in order to fit the holder correctly.
print with support (Recommended: Lines 10% or less)
Preferable but not necessary: printing in an enclosure.
Minimum infill ratio: 15%.
to fix the Modular on the holder you will need extra 4x M4x8mm Hex Screws exactly as the one that comes with the snapmaker 2.0
To fix the lever, you will need the following:
1X M4x16 flat screws.
1X M4 nut. (the hole is hexagonally shaped for nut with 6.90mm in width)
| Date published | 10/05/2020 |