Spoolholder
Spoolholder
Published 2018-08-20T16:12:48+00:00
This spoolholder is another take on the 3d printing nerd design challenge. This version prints faster while still having all of the features. To achive this the spool is now orineted in a 90° angle towards the spools on the shelft, whereas on my other desing the spool on the spoolholder has the same orientation as the spools on the shelf.
If you have a 3/4" (18-19mm) deep board to hang this spoolholder on it might be for you.
Features:
Prints in one Piece, without supports
Fits 30cm (11,8 inch) spools
Loadtested up to 6 kg (13,23 lbs) (using the provided printig details)
can be printed on a 20cm x 20cm (7,9" x 7,9") printbed
no additional hardware needed
NOTE: Check your print for underextrusion since this can significantly decrease the stability, especially when occurring on the small back part.
Material: PLA
Temperature: 210°C
Infill: 20% Cubic
Top- and Bottomlayers: 4
Shells: 5
Date published | 20/08/2018 |
Technology | FDM |
Complexity | Easy |
Support Free | YES |