Sprinkler for Modular Hydroponic System
Sprinkler for Modular Hydroponic System
3D
Published 2020-02-21T14:00:33+00:00 • Remixed from Modular Hydroponic System, Bucket Lid for Modular Hydroponic System
This is an upgrade to the Modular Hydroponics System that adds a friction fitting for a 1/2in tube to come up through the bottom to fill the resivor. There are also holes pre-cut into the module making it a sprinkler system.Â
This module is intended to be used with a system running a hose up the inside of the modules delvering water from the tank bellow.
Also included is a lid with threads for the friction fitting and a sprinkler without threads, this is intended for systems that have the water fed from the outside. Just for options 😊
Works well with this upgrade:Â https://www.myminifactory.com/object/3d-print-111978
For the unmodified parts, such as the vanilla lid, visit the original part page found in the Remixed From section of this page.
The friction fitting and the module print seperately and thread together. The threads are pretty tight and should create a water tight seal on their own.
No supports are necessary for this to print.
| Date published | 21/02/2020 |
| Time to do | 720 - 721 minutes |
| Support Free | YES |