Swivel Nozzle for Jet Engine, 3 Bearing Type, [Motor Driven Version]
$10.00 Swivel Nozzle for Jet Engine, 3 Bearing Type, [Motor Driven Version]
Published 2021-06-16T08:04:53+00:00
This is the “Motor Driven Version” based on “Phase 1” Model for Swivel Nozzle called 3 Bearing Swivel Nozzle (3BSN) for Jet Engine for the recent STOL Fighter, previously uploaded.
https://www.myminifactory.com/object/3d-print-swivel-nozzle-for-jet-engine-3-bearing-type-phase-1-84213
A. Design points:
This model is a complete modification of the following three phases, which were once made as a mechanical tool due to the complexity of the operating motion, as Motor-Driven.
- Phase 2 - #2 & 3 BRGs are geared to synchronize and can be turned by 2 Knobs.
- Phase 3 - All BRGs are connected with Gearbox and can be turned by Single Knob.
- Phase 4 ? Phase 3 + Additional GB. This is my Target Model to turn Single Lever.
In particular, I worked hard to solve about how to absorb large movements of the # 2 & 3 bearing shaft back and forth, up and down, and left and right.
- “Ball bearings” are used for the rotating shaft
- “Steel balls” are used for the slide shaft
- “Metal universal joints” are used for the connections of shaft
It was possible to drive the # 1 and # 2&3 bearing shafts with individual motors, but since each shaft shifts due to the different load, I made a “Synchronous gearbox” to make it one motor.
This model uses a 30RPM DC motor with a 6V battery. It can be used in both rotation directions.
[Video]
https://youtu.be/-_NCzW9pK24
B. Assembly Manual (PDF format, total 22 pages)
The detail assembly manual including "Parts-List", "After printing treatment" and "Assembly procedure" are prepared based on "Standard Skill (Filing, Drilling, Tapping and painting)".
C. Download files includes;
- files: STL Files (47 items)
- “ws” of last 2 digits means “With Support” special designed.
- PDF(Zip) File: Assembly Manual
D. Purchase Parts Information;
- Bearing - 675ZZ or DDL-850ZZ (5x8x2.5) 18ea, 698ZZ (8x19x6) 1ea, WBC6-12ZZ (6x12x4) 2ea
- Steel Ball - φ4, 7ea
- Universal Joint - Commercially available, See photo
- Aluminum Pipes - φ6, φ7
- Screws
Micro screws M1.4x3.5L and 6L - Direct screw-in to 1 mm dia hole (No nut)
But there are many small parts, if you can get M1.4-P0.3 Tap, using it to make introducing thread is recommended.
M2, M3
Quantity and length of screws can be adjusted by your experience.
- Coil Sparing - Tension Type (0.4x6.35x15) may be replaced a rubber band.
E. Total Net Print Time: Approx. 34 HR
- (Estimated as case of PLA, 0.4mm Nozzle, 0.2mm Layer Height, 40% infill and No raft and support)
Note: When at actual print, each parameter may be adjusted by your experience.
For parts having gear teeth, 100% infill and 0.2mm Layer Height are recommended.
See text
Date published | 16/06/2021 |
Price | $10.00 |