Tablet holder (GoPro mount)
Tablet holder (GoPro mount)
Published 2022-04-04T09:30:55+00:00
English
How hard is it to hold the tablet when you are watching a movie or reading a very long document?
The tablet holder was born from this idea, it allows you to keep it in the position you prefer to better see its contents.
The attachment is GoPro, so it can be attached to most mounts.
Why should you download this and not many others?
Simple, no supports during printing, quick snap coupling, light and sturdy structure.
Italiano
Che fatica è tenere il tablet quando guardi un film o leggi un documento molto lungo?
Il porta tablet nasce da questa idea, permette di mantenerlo nella posizione che preferisci per vedere meglio il suo contenuto.
L'attacco è GoPro, così che si possa fissare a la maggior parte di supporti.
Perché dovresti scaricare questo e non tanti altri?
Semplice, niente supporti in fase di stampa, attacco rapido a scatto, struttura leggera e robusta.
Tablet dimension:
244 x 168 x 14 mm (with cover)
Parameter:
Layer: 0.1 - 0.2 mm
Filament: 40g
Time: 7 h
After the printing:
- After the printing is important check the hole dimension with a piece of filament.
- The GoPro attachment must be rotated by 180 ° fitting it into the spherical caps.
- To assemble the parts you must use a piece of filament, heat the ends with a lighter (or thermal gun) and then snap into the hole.
Date published | 04/04/2022 |
Time to do | 360 - minutes |
Material Quantity | 40g |
Support Free | YES |