This print takes quite some time and uses a lot of material, but in my opinion it worth it.
I spent a lot of time trying to fix the annoying wobbling issue using the stock carriage, before printing it.
Now my carriage is solid as I always wanted.
To assemble this, besides the hardware already on the stock carriage, you just need:
- 4x M3 washers
- 4x M3 x 14mm bolts (or a little shorter). Longer than 14mm won't fit.
- Washers and bolts are only to assure the legs will be held firmly in place. Not sure if it's even necessary because everything is very tight, I had to carefully hammer the legs down with a mallet, but I recommend, just in case.
Also chech this:
Vertical X Carriage
Vertical X Carriage (w/ eccentric nut)
If you'd like to support me you can post a make, comment and/or pay me a coffee at PayPal