This was a redesign based off of Ricardo Salomao's EMOJI POOP! found here: https://www.myminifactory.com/object/poo-emoji-16103
"Tiny-Poop_Rev3" is the final version and is ready for action. The earlier revisions are still available if you want to use them for anything go for it! "Tiny Poop BUCK" is the file for if you are going to vacuform this and has the proper design changes to release from the plastic after forming.
You can watch this design print here: YouTube
I made this design to fit 65mm Tiny Whoop frames. There is a small hole in the back for a VTx antenna and the front camera shroud is tilted at 10 degrees and should allow for most camera lenses to fit inside.
I still have a few tweaks to make to this design but I will just update this model when I am done. This design is not to be the actual canopy that goes on top of your whoop. It is a vacuform buck. But hey, you can do whatever you want with the file. Have fun!