Tito biped robot
Tito biped robot
Published 2016-05-26T09:56:14+00:00
Tito walking and dancer DIY biped robot is a derivative design of Zowi which is based on BOB the original biped robot that uses only 4 servos to walk and move. Made the following improvements:
Able to have an Arduino UNO board (or smaller) inside the robot head.
3 LEDs for a simple mouth.
Rounded top head.
Legs thickness increased and reinforced rounds.
Rounded feet top.
Chassis - base simplified.
Easy to reprogram or energize having the connectors in the back.
Additional Hardware needed:
Arduino UNO or compatible, i use a DFRduino R3
Nano breadboard or weld all cables
Buzzer
Futaba servo S3003 x4
HC-SR04 Ultrasound sensor
Nuts M3 x20
Screws M3x12 x20
Powerbank (optional) or just use the usb for power the Arduino board.
Check the schematic picture for connection
The HC-SR04 Ultrasound sensor is not connected in the schematic; trig for pin 8 and echo for pin 9)
Using same original code for Arduino:
https://github.com/bqlabs/zowi
Date published | 26/05/2016 |
Time to do | - 600 minutes |
Technology | FDM |
Support Free | YES |