Turtle Pot
Turtle Pot
Published 2021-06-22T08:32:57+00:00
I designed this 3D model in Fusion 360 based on a 2D crocheted turtle pot holder. I created this for the Cults3D Anycubic Garden contest.
This planter has a drainage hole out the bottom, as well as one out the side to let excess water collect in the dish. The gray paint was an attempt at splatter paint, but did not pan out as I had hoped, but it's overall unique. Enjoy!
This is a very simple and easy print. I sliced everything Simplify3D, printed it on an Artillery Sidewinder X1 and then hand-painted everything with Galeria Acrylic paints.
Resolution: 0.2mm
Infill: 12% (triangular)
Speed: 60mm/s
Temp (Noz/Bed): 210C/60C
Top/Bottom/Perimeters: 3/3/1
Filament: Eryone 1.75mm PLA Matte Olive Green
This model does not require any support structures to print.
Print Time (Approximately): 8H:46M:00S
Date published | 22/06/2021 |
Support Free | YES |