Unifi UAP-IW-HD wall mount spacer for In-Wall HD accesspoint
Unifi UAP-IW-HD wall mount spacer for In-Wall HD accesspoint
3D
Published 2019-08-02T10:46:45+00:00
This wall-mount is a spacer for mounting the Ubiquiti Unifi In-Wall HD access point on a wall or ceiling, effectively making it an On-Wall HD :)
This probably works for the other In-Wall series from Unifi but I haven't tested them.
The supports are needed for the screw mounts for the access point. The holes need to be drilled in depending on the type of screws you use.
When mounting the access point I discovered that the screw mounting blocks for the access point plate are of course hollow with some infill. If you use a higher infill, the screws should work better. Otherwise you can mount it with an M4/M3 bolt and nut.
Added note: Use a self-made cable cable, otherwise the case is not high enough.
Made with Tinkercad.
Good luck with printing!
Printer: Anycubic Mega S
Rafts: No
Supports: Yes
Resolution: 0.3mm
Infill: 20%
Filament: Jupiter PLA PLA White
Notes:
I printed this on 60mm/s speed @ 0.3mm resolution. For a better result you can choose to print it at better resolution of course.
| Date published | 02/08/2019 |
| Time to do | 140 - minutes |
| Material Quantity | 49g, 16.55 meters |
| Dimensions | 132x79x25mm (LWH) |
