UV BLOCK FOR SLA MODELS
UV BLOCK FOR SLA MODELS
Published 2020-09-28T11:48:44+00:00
Блок досвечивания ультрафиолетом моделей после печати полимерными смолами.
Для сборки необходим блок питания для светодиодных лент 60Вт, разъем IEC-320-C8 (по надобности могу сделать дополнительный под нужный разъем), светодиодная лента (у меня ушло 210 мм), вентилятор 4010
UV conditioning unit after printing with polymer resins.
For assembly, you will need a 60W power supply for LED, an IEC-320-C8 connector (if necessary, I can design for the desired connector), an LED strip (I used 210 mm), cooling fan 4010
Main block and it's top - PETG, because printing large ABS models is a hassle
Power block and it's top - ABS, because the power supply heats up during operation, the petg temperature reserve may not be enough
Bottom - FLEX
Date published | 28/09/2020 |
Support Free | YES |