X1 Artillery Filament Guide
X1 Artillery Filament Guide
Published 2020-02-10T17:10:13+00:00
This item is made and tested on my X1 Artillery 3d printer,
I found the default spool holder on top of the printer to be shaky and not so compatible.
I want a solution to place my 3d filaments inside a box, on the bench or just a shelf and feed from there.
hope you find this useful.
will glad to hear about improvements.
and don't forget to post your printing and mounting.
installation:
1.remove default spool and the filament sensor.
2.move 2 of the 4 square nuts of the top bar to the other side of the bar (should have 2 on each side)
3.assemble the part with the filament sensor arm (optional if you use the sensor if not skip this step)
4.place the main body on top the bar and use the 5mm screw (used to hold the default spool holder)
5.if you have filament PTEF tube holder (5mm width) you can screw them one on each side for better tube holding
** you can use it with only PTEF tube inside the hols directly, but not ideal.
p.s: measure twice, print ones.
Recommended 6 perimeters,
10% max infill no need more.
Date published | 10/02/2020 |
Support Free | YES |