It's back... The Dodge Charger R/T is the main car that Dominic Toretto drives in the "Fast & Furious" series. It has been destroyed and rebuilt and then destroyed again. The Charger made a return last time in the seventh film. It is a hero car of this series and especially car lovers would like this 900HP American Muscle.
This is more than just a display piece, as I've modelled it with working wheels - so it's ready to roll right off your print bed!
The software I used to create the charger was Rhinoceros,
I'm a fan of the Fast and Furious series, so it was enjoyable using it to bring one of the most iconic cars from it to life with my own personal replica.
I used the skills I've built up over the years in joints and mechanisms to incorporate moving joints in this model - while still allowing it to be printed in a single piece!
May be my next vehicle will have moving joints for the doors.
printed it with a 0.25 mm layer height and 19% infill clean the support material at the bottom of the body and after removing it, slightly rotate the wheels so that you can break the support between the tire and hinge