picnic table
picnic table
Published 2017-07-05T15:02:15+00:00
I made this on the fourth of july for all the dolls, army men, robots, fingerboarders and.. plastic cowboys, of course. It is print in place and I tried my best to account for tolerance variation across multiple printer styles. Fingers crossed. It is four simple pieces that connect together and end up quite sturdy. The top of the table prints face down and I have found that if the first layer of the print isn't pressed too much(elephant foot) that it helps to keep the slat lines preserved. Hope you like it and please let me know if you have any problems with it.
Rae @theplasticowboy
This object was made in Tinkercad. https://www.tinkercad.com/things/jlQbVuLdmRS
Printing is Patience. Breathe. Exhale. Breathe. Exhale. Breathe. Not too close to the printer though, unless you have proper ventilation.
Date published | 05/07/2017 |
Time to do | 45 - 180 minutes |
Material Quantity | 17m@1.75mm |
Dimensions | 171x91x9.5 |
Technology | FDM |
Complexity | Very Easy |
Support Free | YES |