I just about remember being on pubs with these table top skittles, so with all this new fan-dangled technology, it's time to bring them back.

The aim is to swing the ball to know down as many skittles as possible in as few gos...

The set is comprised of:

• The base
• The Skittle - you will need 9 of these
• The pole - you will need 3 or 4 or these depending how hard you want to make it
• The Cap with integrated spinning center
• The Ball.

Additionally, you will need 10 marbles and a length of string

Stuff made with FDM is light, so to get some weight into the skittles and the ball, pause the prints half way through and drop a marble inside. 

Everything prints without supports, except the cap - I advise adding supports manually to the egg shaped part only so it moves freely after printing.

The poles push together and do not need glue, but you might need to give them a light sanding at the ends, depenting on your printer...