Matt3ry's Print of Dragoon V2 A - 69
Community Print 3D Print of Dragoon V2 A - 69
Published 2020-06-02T04:29:54+00:00
5
2
Printed on: Other
Material: PLA
Description
I used the "Kingroon DIY Aluminum" 3D printer.
The white parts were PLA, but the blue tip was printed using TPU. Aside from being flexible, TPU also has a similar texture and grip to rubber.
The magne weight disk and spin gear's magnecore were not 3D printed, but are instead official parts.
I couldn't find blue stickers on the provided sticker sheet for the back ends of the attack ring's dragon heads, so I used a sharpie instead. I also used a sharpie for the eyes because tiny eye stickers are terrible.
I substituted some of the files for versions of the same parts that I already had on hand for the sake of convenience. That's the reason for some small shape differences, most notably a lack of notches in the bit chip.
Personally, the only thing I don't like about this, is the thinness of the top of the attack ring's bit chip slot. Resulting print ended up looking half-destroyed in those two spots, and I might have been lucky that the bit chip doesn't just slip out due to that.