richstuch's Print of Bugbear - Tabletop Miniature (Pre-Supported)
Community Print 3D Print of Bugbear - Tabletop Miniature (Pre-Supported)
Published 2021-04-24T16:22:28+00:00
1
2
Description
Thanks for the prompt response. See attached image. Had a couple of failures of each type. With the left image, I end up with a splodge on the FEP. With the right image, the bottom comes away from supports but I end up with a nicely printed top half. I'll increase the layer times by about 10-15% and see what happens