I just finished this yesterday. Calvin and Hobbes is my all time favorite comic strip, so I had to print it big. I went with 150% and a .2 layer height. Standing on the log, Hobbes is about 14" tall. It's Huge! I had to cut the log in half and printed it vertically at .3 layer height. I also found out that the stripes turned out nicer if I over-extruded them, so I set my extrusion multiplier at 1.2 in S3D for those. It brings a smile to my face every time I look at it! Just for scale, Kermit and Snoopy are printed at 100%. Printed on an Ultibots D300VS+. The white is PETG, the rest is PLA.