Printed the presupported files on my Elegoo Saturn,
Elegoo WW Black Resin at 0.04mm
Printed both the Base and Body parts solid.
The Body printed perfectly, amazing looking print, sword even came out straight after the post cure. Supports peeled right off with some warm water, can't see any craters so really well done supporting the body too.
The base supports however failed, ripped itself straight off its supports about half way through the print so I'll have to try that again with my own supports. I had both the base and body on the build plate at the same time so was worried the body would also fail but as I said above, the body prints fine.