joenodden's Print of Face Mask
Community Print 3D Print of Face Mask
Published 2020-12-16T21:02:52+00:00
3
0
Printed on: Other
Material: PLA
Description
Welp I printed it. Made a few mistakes seeing as this is my first attempt at a print. I accidentally added supports on the tread so it was a nightmare to get those out, and I ended up just jamming the filter holders on after giving up. However one of the treads seemed wayyyy more loose than the other so I'm not sure if that quirk was an error on my part.
Cut my hands quite a few times trying to remove the supports.
Oh and I made a miscalculation and halfway through I ran out of filament but after resuming it printed just fine.
Overall it took probably about 30 hours to print.