came out ok. i need way more practice at finishing. i tried wood filler on one, and the other just sanding. used satin black spray paint on both.
the one of the left was wood filled. it also had a gap from the top and bottom piece i had to fill. i also used the smallest drill to make a hole for the LED and hot glued it in place.
i had to shave down a section on the inside where the LED went to accommodate for the solder bumps on the LED chip.
sizing isnt perfect. its a bit long. so the back ports are sunken in just a bit too much. so i dremelled the type C port out a bit so the cord would fit all the way in.
overall its a good item.