Thanks for sharing this very nice model. Anet A8. 200 mm tall. Upper 0.08 mm layer height. Lower 0.12 mm layer height. 220/60 °C. 40 mm/s. I split the full model myself rather than use the supplied pieces because I didn't like the flat surface under the arm and hair tips. I rather print with minimal supports to keep the shape of the arms and hair complete. Makes the full model look nicer from front on I think. Also as a test I printed a smaller unsplit version 100 mm tall and 0.2 mm layer height with custom supports made in Zbrush with Zspheres. Worked quite well so I may reprint a taller, higher resolution version in the future. This is a gift for my daughter's birthday so I added a cylindrical maze puzzle in the skirt to hide an additional gift. Figurine is perfect for that. Thanks again. I had fun printing this.