kennethong's Print of Shark-Man Captain
Community Print 3D Print of Shark-Man Captain
Published 2020-08-08T17:30:51+00:00
2
1
Material: Resin
Description
Subscriber from Patreon here. tried resizing it to 80% but sadly didn't print as well. will try to rescale it again a little bit bigger, but I wish it was available at 75mm.I used the pre-supported file.
Printed on: Creality LD-002R
Resin used: Creality UV resin Gray
Setttings:
Layer height: 0.05mm
Bottom Layer Count: 5
Exposure time: 7Bottom
Exposure time: 40s
Light off delay and Bottom light off delay: 0 sec.
Bottom lift Distance: 5mm
Lifting Distance: 5mm
Bottom Lift Speed: 60 mm/min
Lifting Speed: 65mm/min
Retract Speed: 150mm/min