ragonfand's Print of The Black Spindle Exotic Sniper Rifle from Destiny
Community Print 3D Print of The Black Spindle Exotic Sniper Rifle from Destiny
Published 2018-07-05T23:08:46+00:00
0
0
Printed on: Creality CR-10
Material: PLA
Description
the total print time was 14 days 22 hours, I ended up using 3/16” full thread rod, two part epoxy was used to glue it all together, the current paint job is stain black and flat soft iron and flat black for the mag
Problems encountered, I had issues with the receiver leds didn’t appear to channels from the wire and I ended up drilling holes in each side to run the wires