220mm Flower shaped Pinwheel with ball bearing
220mm Flower shaped Pinwheel with ball bearing
Published 2020-04-20T20:50:11+00:00
I wanted to practice my first twisted thing with Fusion 360. The outcome was a nice pinwheel. Use a standard 608-2RZ (22x8x7) ball bearing and it will start to spin at a light breathe already.
Use a M4 screw trough the angle mount to fasten the spinner.
Hot glue a stick up to 10mm diameter into the angle mount. I used a small banboo stick.
You also make like some leaves as addon: Rotating Leaves
Good luck printing this thing and have fun.
Print Settings
Printer: Tronxy X5S
Outside Brim: Yes
Supports: No
Resolution:0.2
Infill:30%
Notes:
Because the pinwheel has a small surface to stick to the bed I recommend to use outside brim of about 5mm. Therefore the printbed dimension has to be at least 230mm square or round.
Date published | 20/04/2020 |
Support Free | YES |