Bosch E Bike charger BCS220 holder (to be used with YAS)
Bosch E Bike charger BCS220 holder (to be used with YAS)
3D
Published 2022-03-11T09:09:03+00:00
Introduction
This is a holder / bracket for the Bosch E-Bike standard charger BCS220 (4A). To be used with "Yet Another Shelf" (YAS).
What you need
Time: Printing time is > 7h
4x socket head screws 3x12 mm
4 washer M3 (outer diameter 7mm)
Disclaimer
Neither mechanical nor thermal tests have been done. It is unknown how much load the holder can take. This “thing” has been published so that it can be used and re-mixed by anyone. Especially no experience has been gathered how the thing behaves if the charger gets hot. Use at your own risk.
The slicing has been done so that the holder prints upright to avoid visible print enforcement on the top. However, this comes with a very long print time and alot of wasted filament.
| Date published | 11/03/2022 |
