Cat Cable Combs - Modular Design
Cat Cable Combs - Modular Design
3D
Published 2020-08-11T14:06:17+00:00
I am excited to bring you a multi adapter modular combing (marketing keywords) prints that allow you to add or remove as you seem fit with your CAT5(e)/CAT6(a) cables. These prints will be your one stop shop for cable management between devices in all environments.
With the printed parts you will be able to snap in the parts that are required for your needs.
If you only have free floating cables then you do not need to print the end caps for a M2-M4 screws/bolts. If your hardware is larger than M4, you can drill out the hole to your needs. If smaller, then you can utilize a washer to fit your needs.
Notes:
*NOTE* Print with the adapters on their sides to provide the highest quality outcome. Do not attempt to slide the parts together. They are designed to be push into a clipped position.
Printer brand:
Creality
Printer:
CR-10
Resolution:
.10mm
Infill:
0-50, after 50 is unnecessary
| Date published | 11/08/2020 |
| Benoetigte Zeit | 16 - Minuten |
| Menge an Filament | 1g |
| Dimensionen | 13mmx11mmx10mm |
| Support Free | YES |