Collapsing Middle Finger - Zombie Edition
$2.00 Collapsing Middle Finger - Zombie Edition
3D
Published 2024-04-29T15:39:37+00:00
Zombie Middle Finger - Because Zombies also deserve to flip someone off 🧟
So this is the Halloween edition of my Collapsing Middle-Finger! There are 2 versions as explained here:
Small Tip: will allow the finger to fall down and could cause her to spin inside 180 degrees randomly - For me it's not a big deal you play with it once or twice and it spins back but maybe some of you don't like it hence - Bit Tip
Big Tip: With this version the finger cannot fall below the external walls as the tip is bigger - Slightly different visual to resolve this issue that may annoy some.
I recommend not going below 60% scale - I was able to print it at 50% but it's not designed to go lower.
Tips:
Avoid using a brim if you can and just watch the first layers as the bridge above the lower collapsing parts is built - This is the toughest part to print (Use glue stick if you have adhesion problems on that part)
You HAVE to make sure you don't have an elephant foot in the first layers.
If the finger wobbles:
1. Use glue / make sure your adhesion is good
2. lower speed
3. Enable z-hop
4. Check Z height make sure it's not to close to bed
if walls get fused:
1. reduce flow / width of first layers
2. make sure you don't have an elephant foot
3. Randomize your Seam
| Date published | 29/04/2024 |
| Price | $2.00 |
| Support Free | YES |