CR-10 Ender Hemera Reversed Mount [Dual 5050]
![CR-10 Ender Hemera Reversed Mount [Dual 5050] image](https://cdn2.myminifactory.com/assets/object-assets/5f0ae9ec370de/images/70X70-20200423-182056.jpg)
![CR-10 Ender Hemera Reversed Mount [Dual 5050] image](https://cdn2.myminifactory.com/assets/object-assets/5f0ae9ec370de/images/70X70-20200423-182119.jpg)
![CR-10 Ender Hemera Reversed Mount [Dual 5050] image](https://cdn2.myminifactory.com/assets/object-assets/5f0ae9ec370de/images/70X70-capture.jpg)
CR-10 Ender Hemera Reversed Mount [Dual 5050]
3D
Published 2020-07-14T16:40:02+00:00
NOTE: this is a reversed mount, the hotend fan faces RIGHT, not left. I chose this mainly as it places more weight closer to the M5s and it puts the Nozzle a lot closer to its original position on V6/OEM mounts. Meaning less confusion about offsets etc.
Here is my 6-8 month build of a hemera mount
Listed the whole thing as a remix as I copied the slots on the cooling wings
Base Parts Needed, 4 M3x5 and some 4*M3x15 for the fans and 4 similar for an endstop
Printed: 1 of each except 2 M5 washers (also provided)
More M3x5 for the probe mount, and the dual fan spacer is any M3s longer than 12mm
Overall print instructions are
Layer height 0.2mm
No supports, print BP7 (baseplate) upside down and two M5 washers (for the top two M5s)
Use the washers on the top two m5 screws (screw-head) side and DO NOT screw the baseplate onto the gantry yet
Place and hold in 3 M5 nylock (or normal) Nuts into the baseplate
You must use 4 M3x5 screws to screw the back of the baseplate onto the hemera, use a cross screw pattern.
Then you may use the three M5 gantry screws to attach everything to the printer. Make sure to sufficiently tighten them and then rotate the eccentric, recheck the bottom M5 is tight and tension the eccentric.
Fan wings are designed to be Ugly printed at 40 degrees on the obvious flat bit. Attach with two M3s on the back side of the base plate. They house 5010 blower fans so use 15mm or similar screws. Adjust wing height so they blow UNDER your block, but dont screw your part. I admit the fan wings do melt a bit over time, but not enough to impact performance. Full stp included, remix and shorten if you want but I honestly just took them off and chopped them like carrots with a knife.
Lastly this is designed for EZABL probes but full .stp included for anyone that wants to remix the probemount files for BLtouch etc.
Cooling fan here is a 4020Noctua, but the Probemount is the only thing that can limit you, if you want one that works with smaller fans cut a notch off or comment here and I can do it.
Probe Offsets
X_PROBE_OFFSET_FROM_EXTRUDER 0
Y_PROBE_OFFSET_FROM_EXTRUDER -25
| Date published | 14/07/2020 |