Go Pro Monitor Webcam mount for Dell P2715Q
Go Pro Monitor Webcam mount for Dell P2715Q
Published 2021-01-25T09:38:10+00:00
I use a Go Pro 4 as my webcam currently and the original mount took up a lot of desk space on my cluttered desk.
This mount uses a tension clip to mount the standard Go Pro's adjustable arm to my Dell P2715Q. The monitor mount has a dovetail tongue for mounting.
Cable management hooks keep everything tidy and double as pinch handles to pull the tension clip apart enough to easily fit it over the monitor.
The parts have a .02 tolerance between the parts. If that is too loose for you, I have found a single piece of duct tape on the dovetail surfaces adds just enough friction and reduces the gap to make for a nice, tight fit.
Everything prints without supports. You'll need a single M5 hex bolt for the Go Pro to thread into.
File types available are Fusion360, STL, Step, and Prusa MK3S gcode.
Here is my process:
https://youtu.be/EIIQfZgNd4M
Prints without supports.
The Go Pro part needs to be printed with the "hoops" perpendicular to the print bed to print correctly.
I printed both parts on a Prusa MK3S at .2 layer height and the total time was about two hours or 1 hour per part. You can try printing them both at once and turn off ironing, but I err on the side of low and slow for best results.
You'll need a M5 Hex Bolt for the Go Pro to thread into.
Date published | 25/01/2021 |
Benoetigte Zeit | 2 - 10 Minuten |
Dimensionen | 77mm X 32mm X 40MM |
Support Free | YES |