Industrial Fixtures/ Doors/ Hatches for War Gaming Boards
Industrial Fixtures/ Doors/ Hatches for War Gaming Boards
Published 2014-08-22T17:25:51+00:00
I have created three different simple easy to print industrial themed pieces to add to any war gaming board. I specifically play Necromunda, but they will really work on any game board. I wanted to make the board we play on detailed and eciting to look at without having any structures permanently attached that would get in the way of models/ other terrain.
I have created three different models, two which are pictured above:
-Blast doors
-Sewage Grate
-Round floor hatch
Print at any resolution though beware of peeling, stick down to a game board and then sand/flock around/over some of the details. The details below are for all three files printed at 0.15 resolution with 15% infill. I printed them at .3mm resolution which worked out just fine since I ended up weathering them to make them seem rusty and more incorperated into the board. Also the game board was made from a sheet of Blue Insulation foam cut into 2' x 2' squares that was painted with elmers glue, dusted with sand, painted black, then dry brushed.
Date published | 22/08/2014 |
Benoetigte Zeit | 100 - 120 Minuten |
Menge an Filament | 25g |
Dimensionen | Within 10cm x 10cm x 10cm |
Schwierigkeitsgrad | Very Easy |