iPhone 6s Bike Mount
iPhone 6s Bike Mount
3D
Published 2020-10-17T12:15:20+00:00
This is a phone mount for an iPhone 6s. It is designed with the goal in mind to be as slim as possible while at the same time provide sufficient stability. The mount can be attached to any tube/stem of the bike smaller than 34 mm.
The part can be fixed to the bike with cable ties. To avoid damaging your bike, please consider placing a soft material (e.g. rubber) between the part and your bike before tightening the cable ties.
I've been using it for a couple of months now for road and gravel cycling. The phone hasn't dropped out once, even though I went over some pretty hard bumps.
I've tried printing this part in PLA and PETG and prefer the PETG version. It's a bit more flexible, so it's easier to get the phone out. To avoid damage to your iPhone, please carefully test your print and the properties of your material before using it to hold the phone.
To secure the phone on the mount even better, I can recommend placing a rubber band in between the phone and the mount, as this will make sure the phone won't slide up or down.
| Date published | 17/10/2020 |
| Support Free | YES |
