I am a big fan of Jeep's, and especially the old school Willys. And Jason from Ossum Designs did an amazing job on his 3D printable Willys. I have printed the Jeep out at 133% for my Axial SCX10 and wanted to try out a small version for my Losi Trail Trekker. I had to do some big modifications to get it to sit nice and low on the chassis, but worked out pretty good!
I made some mounts out of styrene and magnets but would like to design some 3D printable mounts to make it easier for everyone. So that is still in progress and will update when the time comes.
Direct fit onto a Losi Trail Trekker Chassis. You will have to move the ESC to the front or back instead of the middle, so some minor electronic relocation.
Once everything is printed I just glued the bodies together with some super glue. I attached the hood with a magnet and that is where I keep the battery for some weight up front!
Also check out my Instagram, Twitter, and Facebook pages! Much more stuff there including a Scale garage, Offroad park, and many Props!