Nespresso Capsule Filler / Holder
Nespresso Capsule Filler / Holder
3D
Published 2019-07-29T17:46:49+00:00
NESPRESSO capsule Filler
I've created this design because there is no 3d printable capsule filler.
I make it for the most used coffee capsule maker, Nespresso.
This design is simple and fast printing, about an hour to print it and, after some prototypes I make, it fits perfectly to Nespresso capsules. I've tested it with a 0.32 layer height and 10% infill and it is pretty strong... but if you want to have prettier definition on logo you can print it with classical 0.2 layer.
This design is intended to facilitate the operations of filling and reusing capsules from Nespresso. The only thing you have to buy is foils and coffee :)
Each coffee will cost you from an original 20/30 euro cents to 3/4 euro cents.
Good coffee to everyone!
| Date published | 29/07/2019 |
| Benoetigte Zeit | 60 - 120 Minuten |
| Support Free | YES |
