Nintendo DS Lite Replacement Stylus
Nintendo DS Lite Replacement Stylus
3D
Published 2020-11-18T13:50:30+00:00
This is my design for a 3D Printable Stylus for the Nintendo DS Lite. I've designed it to be pre-rotated for perfect printability, and it requires very little to no post processing.
If you'd like one, but have no printed, I am selling them on my store found bellow.
etsy -
http://www.16bitgamestore.etsy.com/
eBay -
https://www.ebay.ca/usr/16bitvideogamestore
Requires a raft for best quality bed aheasion.
100% infill isn't necessary but it does feel nicer.
0.2mm layer height can be used, but 0.1mm is advised.
The model is pre-rotated for the perfect first layer, just rotate the model 90 degrees in your slicer until the stylus is on it's side. Once there check to see if the first layer has a dot on it, if it does it'll print perfectly
| Date published | 18/11/2020 |
| Benoetigte Zeit | 25 - 40 Minuten |
| Menge an Filament | 1.87g |
| Dimensionen | 86.5mm x 7.5mm x 4.8mm |
