Prusa MK2 Hemera Mount
Prusa MK2 Hemera Mount
3D
Published 2020-01-01T22:50:13+00:00
*** Reworked some features and added back a few brass inserts for rigidity.
*** Had to edit the brass inserts to only 3 since I left out the lower belt slot. I still think that will be more than sufficient since the original was held on with zip ties.
*** 1/1/20: Edited the bottom of each mount for a bit more meat for the brass inset and screw. Added some zip tie holes in the wire chase and a few more fillets overall. I have printed the files and the fit well overall. I have not been able to test it with the Hemera yet since I currently do not have the unit yet. This will be going on an old Prusa MK2S modified to the full Bear version when the extruder arrives.
Original: Here is what I came up with for the Prusa MK2S. I think this will work but I have not tried it yet. It does require brass inserts from the red to green parts. Based off the X -carriage from Zaribo. Can't wait to try it out and see. Anyone willing to double check my work?
Still a work in progress but I don't see any reason this would not work. The PINDA probe should be in the same location as well as the X end stop hopefully.
Forgive the crude drawing but was in a hurry and did not feel like firing up Fusion again.
Affiliate Links for materials:
M3 Brass Inserts: https://amzn.to/39s0HuW
M4 Brass Inserts: https://amzn.to/2Fcva2e
Brass Insert Set: https://amzn.to/37t6miG
Filament: https://amzn.to/2ZMelEH
I recomend PETG or ABS; 30%-40% infill of choice; 3 walls; 4-5 top and bottom layes @ .15 layer height.
| Date published | 01/01/2020 |
| Benoetigte Zeit | 300 - Minuten |
| Menge an Filament | 60 |
| Dimensionen | 150 |