Rollers and Filament guide for Formbot/Vivedino printers stock spool holder
Rollers and Filament guide for Formbot/Vivedino printers stock spool holder
3D
Published 2019-06-19T10:42:00+00:00
I quickly became frustrated with the stock spool holder on the Forbot/Vivedino Raptor 2 needing to adjust it constantly for different size spools of filament.
So with a few minutes in Fusion360 and a couple revisions we have a set of rollers that fit snugly over the bearings of the stock spool holder and a filament guide that slides snugly into the slot on the stock uprights.
This set up works great up to about 450mm Z height prints, anything above that and you need to remove the filament guide.
I printed the system in Atomic filament CF PETG for the set on the printer and the other set is in Matterhackers build series GITD PLA and CC3d Gold.
.4 nozzle
.2 layer height
20% infill
For the rollers be sure to use a brim unless you have super bed adhesion.
| Date published | 19/06/2019 |
| Support Free | YES |