Soap dispenser “bubbles”
$3.00 Soap dispenser “bubbles”
3D
Published 2023-06-02T13:19:37+00:00
Would you like to support my work? :)
Become a member to get access to my full catalogue with exclusives, early access and discord benefits
A beautiful soap dispenser intended for refilling. Upcycle a dispenser of a used soap bottle to create this piece. Avoid some plastic waste and have a unique soap dispenser in your bathroom!
Fill Volume: 300ml
Step-by-step
- Find an empty soap dispenser bottle and unscrew the pump. Alternatively, you can buy high end looking pump, too.
- Measure the diameter of the opening of your pump where the thread sits.
The threads of these dispensers are standardized. Most widely used are GPI/SPI Neck finishes. I included the two most common types that fit the majority of such pumps.
Soap_dispenser_A: fits 28/400 28/410 28/415 threads with a pump opening width of approximately 28 mm (1,1 inch) that fits bottle mouths of 26 - 28 mm (1.02 – 1.10 inch)
Soap_dispenser_B: fits 24/400 24/410 28/414 threads with a pump opening width of approximately 24 mm ( 0,95 inch) that fits bottle mouths of 23 - 24 mm (0.90 – 0.95 inch)
- Choose your file and print it
- Check the length of the pump tube. If the original bottle was about 250 – 400 ml it should fit. If you use a pump intended for a originally bigger bottle (f.e. 500ml) it may be a bit too long. Cut off a piece of the tube with scissors to make it fit.
- Fill the print with a liquid soap refill bag and buy those from now on
- Have fun and enjoy avoiding some plastic waste along the way!
Size of the print: 84 x 76 x 139 mm
- Required build volume: 100 x 100 x 150 mm
- Material usage: 80g
- Print time: 6h – 7h
- Material: PLA
- Print direction: stls are rotated correctly, check images
- Support: none
- Nozzle size: 0,4 mm
- Line width: 0,4 mm
- Layer height 0,2 mm
- Outer walls: 3
- Infill: 15%
- Build plate adhesion type: none
- Watertight printing: If you have a well set up machine it comes automatically - Otherwise here are some tips: Increase your wall count (at least 3), level your bed nicely, decrease print speed, increase layer height (at least 0.2mm), increase print temperature, check your seam quality, calibrate your e-steps and fine tune your retraction settings to make sure no holes appear after a layer change.
| Date published | 02/06/2023 |
| Price | $3.00 |
| Support Free | YES |