The angry ogre
The angry ogre
3D
Published 2019-01-28T17:58:27+00:00
You can have a better look at the model on my sketchfab (https://skfb.ly/6GyPO). A like would be very much appreciated =)
I have printed this model with 100% infill on my Anycubic mega. But it needs probably 5%, I made sure no floating parts inside.
Dunno why but at 200% the original size (about 6cm tall) I had some failures while printing the legs. This one I printed without failures at 300% size (about 10cm tall).
Ok guys so, I did this ogre for a challenge and decided to share with you all. This is the first of many to come.
HOPE YOU ALL LIKE! =)
Some tips while preparing for print:
SUPPORT: are of course necessary. For the left arm, right elbow, chin, skirt, and weapon.
Do not forget between some fingers and teeth.
I printed 100% infill (not needed), print speed 30mm/s, layer high 0.2mm.
| Date published | 28/01/2019 |
| Benoetigte Zeit | 8 - 30 Minuten |
| Menge an Filament | 100 |
| Dimensionen | 67mmX68mmX112 |