Adjusted into 2 sections to be able to print on a smaller format 3d printer. Joined together, it makes a 25cm high model that pivots at the waist. Printed on a flashforge finder on standard settings. be careful where the supports fall on the top section. Make sure there are enough supports to support the bottom of the 'C' shaped claws properly. Also don't let the supports touch the front side of the top section as this can leave marks when removed. Careful placement of the supports is key to a quality 3D print. Again, feel free to amend the design to your choice if required. Top section will require a long print time even on standard setting.