Nunda's Print of Injured Hill Giant
513
views
0 comments
Loading comments...
Community Print 3D Print of Injured Hill Giant
Published 2022-05-29T21:02:03+00:00
0
0
Printed on: Anycubic Photon Mono X
Material: Resin
Description
I had some issues with this print separating from the bed. The back of the arm did not fully print so I made some minor adjustments to make it look like a bad burn. The slice at the neck and down the chest was a bad separation that I made into a deep sword wound. With some basing and some blood, I think I did an okay job of saving the print.