ShayneHert's Print of WOD2 Core Set (pre-supported)
Community Print 3D Print of WOD2 Core Set (pre-supported)
Published 2023-03-22T01:50:29+00:00
0
0
Printed on: Elegoo Saturn 2 8K
Material: PLA
Description
So far I have just printed the Adult Green Dragon from this set. The sculpt is amazing, I just wish the model was cut up differently. I noticed a few of the dragons have their hands (like this one) attached to the base. It became an issue during painting and then when it was done the seamlines showed pretty boldly. I will post more photos after printing and painting the rest of these beautiful dragons.
Side note; I did print the Drakes and Wyvern also but had failures with all of them for one reason or another and I couldn't figure out what scale they are supposed to be. If these "minis" are for dnd 5e then the Adult Dragons are scaled correctly as "Huge" (3-inch bases), but the Wyverns and Drakes are way too big. Sorry for the nerdy "um, actually" I just thought I was nuts and had to double-check the DMG and MM to see if I was losing my mind. Scaling the Drakes down to Medium/Large creatures resulted in a loss of detail and failed prints, so they may just work best as art pieces if I try printing them again.