1/10 Scale TRD Offroad 1.55 Wheel
1/10 Scale TRD Offroad 1.55 Wheel
3D
Published 2021-08-29T18:40:47+00:00
This is a Toyota TRD Offroad Wheel in size 1.55 Dia made for the Element Enduro Knightrunner (Toyota Tacoma). These are 1 piece hubs which will require the tire to be glued to the hub.
There are 2 pieces, the wheel itself and a small hub cover. The hub cover is a press fit and can be a little diffult to remove depending on your printer settings but it looks super scale when installed and only takes 15 minutes to print on ultra quality if you mess it up.
The wheels I print hex side down with support and 20% infill on .16 quality sliced in Cura. They take approximately 4 hours to print each. The hubs are printed with the Toyota emblem up with a brim and supports.
In the pics the wheels are painted with a Molotow Liquid Chrome 1mm paint pen which can be found at Hobby Lobby in the model paint aisle.
These were printed on a Creality CR-6SE. Hope you enjoy them for your scale model build, feel free to tip if you enjoy them.
| Date published | 29/08/2021 |
Have you made, or are you able to made the 2022 TRD Pro wheels for the Element Knightrunner?