1/64 GAS STATION - HOT WHEELS/DIECASTS DIORAMA
$4.70 1/64 GAS STATION - HOT WHEELS/DIECASTS DIORAMA
Published 2022-04-11T15:01:58+00:00
NO COMMERCIAL USE ALLOWED UNLESS you are a member of my patreon. For full access to all models + exclusive models and the right to sell your physical prints on any platform join here:
https://www.patreon.com/PA1_MAKER
GAS STATION DIORAMA
Scale 1/64, for small diecasts like HotWheels, Greenlight, Matchbox etc.
Everything prints well on a fdm printer and fits on an Ender 3 bed.
Lots of details
100% support free (need good bridge settings)
Detailed instructions included.
No hardware needed. Everything is glued together.
All parts already placed in the right orientation, all parts were printed and tested.
IMPORTANT NOTES:
In this one, i have included very small details. They print fine on a fdm printer, as you can see on my picture. BUT: For the small parts and details, use a fine layer height (0.12 or 0.15) and check your temperature to prevent stringing.
The Signage MUST BE DONE with an extrusion width of 0.35 instead of 0.4. You will get better results this way. 0.4 will work too, but you may have some small parts of the letters that are missing.
For the colors of the signage, simply use a color change. The letters are lower than the contour, so its easy to have 3 different colors (backgroung, letters and outer ring) with a color change at the appropriate layer height.
When glueing the windows, be carefull. The glue will show through the windows. Apply the glue on the contour of the part and not in the center to prevent this.
If you have any problems, as usual you can contact me here or directly on my facebook page:
https://www.facebook.com/PA1MAKER
Patreon page to support me:
https://www.patreon.com/PA1_MAKER
Date published | 11/04/2022 |
Precio | $4.70 |
Sin apoyo | YES |