90s Coca-Cola yoyo replica
90s Coca-Cola yoyo replica
3D
Published 2021-09-06T10:36:24+00:00
A fully functional 90s coca-cola yoyo replica. Requires a M3x20mm bolt and nut.
The 2 bases (white coloured parts) require VERY minimal support to print the inside.
Assembly instructions:
Use the "screw pulling technique" to fix the nut in place. Take one side of the base (labelled A in picture) and place the nut over the hole on the outside. On other side screw in bolt and tighten until it pulls the nut into the hole. Remove bolt.
Assemble the bearing. Fit both pieces B and C together until edges flush. Should be a 2.5mm gap for the string.
Put everything together like pictured. M3x20mm into base (D) without nut, through the bearing (B+C), and into the base with embedded nut (A). Tighten with allen/hex key. Fit outside coloured panels (E and F)
If you like my designs and would like to see more please consider donating/tipping.
| Date published | 06/09/2021 |