A better and faster stackeable visor/faceshield
A better and faster stackeable visor/faceshield
3D
Published 2020-04-08T07:40:12+00:00
This is a redesign of the (stacked) visor by 3D verkstan. It has some major improvements:
- The diamond shape will have the perimeter lines stacked as a brick wall for improved inter-line adhesion
- The small top and bottom area will make seperating them a lot easier
- there are small pillars in between the parts for better connection preventing warping while still being able to seperate them easily
- There is an integrader brim/raft for the first layer that can be serepated in the same way.
The files are:
- Single visor
- Visor that can be stacked (STL and STEP)
- A stack of 36 (just shy of 200mm)
use PrusaSlicer! Due to the vast amount of gap filling perimeters this is the only slicer that will print it sensibly.
The model is designed for:
0.45mm line width across the board
0.32mm layer height (incluiding first layer)
Other preferred settings:
4 perimeters
0% infill
no fan
high speed (90mm/s will generate 1 visor every 17min)
| Date published | 08/04/2020 |
| ¿Cuándo tiempo lleva? | 17 - minutos |
| Dimensiones | 200x200x200 |
| Sin apoyo | YES |