Bearing - Needle Roller type one piece print (with minimal support to remove)
Bearing - Needle Roller type one piece print (with minimal support to remove)
Published 2017-03-29T09:49:26+00:00
Great 'proof of concept' 3D print... this amazes everyone not familiar to 3D printing!
This needle roller bearing prints as one piece. It has 12 rollers and prints (on a Replicator 2) so the designed in support can be removed in next to no time to leave an easy to spin needle roller bearing.
At the time of uploading I couldn't find anything similar on Thigiverse. The key to it working is the clearances within the design and the designed in support.
TIP: Spray inside from each side with a small squirt of silicone spray to make it spin really well.
Easy print... something to fascinate people with.
Print slowly with good resolution. .06 or better. This model has built-in support that will not print at higher resolution, or if you print too fast. You also must print at a minimum of 35% infill, but 40-50% full honeycomb may yield better results if you are having trouble. After it prints, clearing the tiny supports from the bottom is quite easy, and a little bit of silicone based lubricant will help to get your bearing spinning smoothly.
Date published | 29/03/2017 |
¿Cuándo tiempo lleva? | 60 - 90 minutos |
Cantidad de filamento | 10 grams |
Dimensiones | 36.6mm x 36.6mm x 16mm |
Tecnología | FDM |
Complejidad | Medio |