Bed Handle for Sindoh 3DWOX DP200 - Machine Spare Parts (DIY)
Bed Handle for Sindoh 3DWOX DP200 - Machine Spare Parts (DIY)
3D
Published 2018-04-30T11:14:21+00:00
Here we share the bed handle design which was asked by most users in the past.
By this, you are able to fix the bed handle problem DIY now.
Please follow the printing details below and let us know if any question while printing.
For further question, please ask us on Contact Us at https://3dprinter.sindoh.com/
1. Download the *.gcode file from this page.
a. For PLA, please download the 3DWOX Bed Handle_PLA.gcode.
b. For ABS, please download the 3DWOX Bed Handle_ABS.gcode.
※ 3DWOX Desktop will not let users print PLA gcode files with ABS cartridge installed and vice versa.
2. Print the *.gcode file through the 3DWOX Desktop Software.
a. The *.gcode file will print the main body and the handle, separately. Please assemble the parts by pushing the handle into the main body.
b. We suggest applying super glue or any other high-strength adhesive after the assembly.
3. Pull the Printing Bed out of the 3DWOX.
4. Loosen the four screws off of the Bed Handle.
5. Pull the original handle off of the Printing Bed.
6. Push the new handle in and tighten the screws.
※ CAUTION! Strong Tightening of the screws will result in the crack on the new bed handle!
※ Please tighten the screws slightly until applying strength is needed and with care!
As a temporary measure, please plug in a soft sponge-type material inside the push tap as shown in the last image in order to lock it tightly.
| Date published | 30/04/2018 |
| ¿Cuándo tiempo lleva? | 53 - 60 minutos |
| Dimensiones | 93.5 x 11.45 x 16.07 |
| Sin apoyo | YES |