Bookshelf conversion for filament storage
494
visitas
14
descargas
0 comentarios
Cargando comentarios...
Bookshelf conversion for filament storage
3D
Published 2022-03-07T10:59:55+00:00
1
0
Add to Collection
Descripción
When you repurpose a F-railsystem to hold filament spools then you need to angle the shelfs a bit. You could just put a thin piece of wood, plastic, or what ever underneath or make a little adapter for it.
So I made a little adapter to put on the end hook of the shelf arm and raise the front 3mm, this gives the shelf a slight angle so the spools roll to the back.
The quality of the print didn't matter so I used my EasyThreed X1 and some (litteral) neutral filament, and printed 8 adapters.
Licencia
Detalles de impresión
Nozzle 0.4
Layerheight 0.20
Wall count 3
Top/Bottom layers 4
Infill 20% (Grid)
No supports
Because of the printer I had to set "Initial Layer Horizontal Expansion" to "-0.2".
Información técnica
Date published | 07/03/2022 |
Sin apoyo | YES |
Más información
Archivos